Kreg K5 Pocket Hole Jig Mount

BySCWD

Something I should have done a long time ago. I made a mount for my Kreg K5 system. I love that I don’t have to take it off the shelf and take everything out and go through a big setup. Now, I just grab the mount off the wall and clamp it down. Of course hook the vacuum to it. Less steps is better sometimes! The vacuum clips by Powertec came in handy for securing the hose to the jig. I purchased a 5 pack of the Powertec 2.5″ hose clamps. I used two on my jig and the rest for my ShopNotes ShopVac Cart.

The jig itself was very easy to make. It was the YouTube filming that took most of the day re-positioning this, re-positioning that….

Very pleased with the jig, and I highly recommend you build one for yourself.

Materials Used:

  • 3/4″ Common Pine Plywood
  • Kreg Pocket Screws
  • Constructions Screws
  • 2 x 4 Stud
  • PowerTec 2.5″ Hose Clamps
  • Titebond II Wood Glue

Youtube Episode

Build Photos

Similar Posts

  • Hot Glue Gun Station

    BySCWD

    I was in the shop using my hot glue gun and finally decided to make a holder which turned into an elaborate station. I definitely experienced OCD on this project. I tried to think of every conceivable thing that I would need in the future. I didn’t want to do what everyone else had done….

  • Kreg K5 Stop Collar Jig

    BySCWD

    While I was building my adjustable height workbench I experienced a lot of long and  heavy boards. This created a problem for accurate drilling of pocket holes. Regardless of the Kreg K5 built in clamp, the boards would lean or shift due to the length and weight of each board. I didn’t see the necessity…